BitFlow

Blink

The board's clock ticks CLK_HZ times a second (27 million on a Tang Nano 9K). A register that counts the ticks can measure time: after CLK_HZ / 2 ticks, half a second has passed.

always @(posedge clk) runs on every tick. Count up, and when the counter reaches the end, start again from 0 and flip the LED.

On the virtual board the clock runs at 1 kHz so you can watch it; on a real board CLK_HZ is set to its oscillator.

lab.v
drag to turn · scroll to zoom

Loading the board…

Press Run on the board: your Verilog is turned into gates in this browser and runs here, cycle by cycle.

Goals

  • ○LED 0 blinks
  • ○It changes every half second
Hints
  1. Use a counter wide enough for CLK_HZ / 2: 32 bits is plenty.
  2. When the counter reaches CLK_HZ / 2 - 1, set it to 0 and do on <= ~on;.

Pin log

Run the design to see its outputs change.

Put it on a real board

  • The clock is set to the board's 27 MHz, and its active-low buttons and LEDs are flipped for you.
Waveform