BitFlow

Doorbell

A press of button 0 starts a little tune: 660 Hz for 0.4 s, then 440 Hz for 0.6 s, then silence until the next press.

That is a state machine (quiet, ding, dong) where each state has a pitch and a length, the same pattern as the traffic light, with the beep's tone generator underneath.

lab.v
drag to turn · scroll to zoom

Loading the board…

Press Run on the board: your Verilog is turned into gates in this browser and runs here, cycle by cycle.

Goals

  • ○Silent until button 0 is pressed
  • ○Ding: 660 Hz for 0.4 s, then dong: 440 Hz for 0.6 s
  • ○It stops by itself after the dong
Hints
  1. Three states and one timer; the state picks the half-period (CLK_HZ / 1320 or CLK_HZ / 880).
  2. Start on the button going down, so holding it doesn't restart the tune.

Pin log

Run the design to see its outputs change.

Put it on a real board

  • The Sipeed Tang Nano 9K (Gowin GW1NR-9) has no a buzzer: those ports go to header pins, where you can wire them.
  • The clock is set to the board's 27 MHz, and its active-low buttons and LEDs are flipped for you.
Waveform