BitFlow

Keypad scanner

A keypad is a grid of 4 row wires and 4 column wires; a key joins its row to its column. The columns are pulled high, so drive one row low at a time and see which column goes low: that is the key at that row and column.

Scan the rows over and over, and when a key is down, show it on hex0: digits as themselves, A–D as A–D, * as E and # as F.

lab.v
drag to turn · scroll to zoom

Loading the board…

Press Run on the board: your Verilog is turned into gates in this browser and runs here, cycle by cycle.

Goals

  • ○Digit keys show their digit
  • ○A–D, * and # show A–D, E and F
  • ○Only one row is driven low at a time
Hints
  1. row cycles 4'b1110, 4'b1101, 4'b1011, 4'b0111; a 2-bit counter picks which.
  2. Look at col while a row is driven; a 0 bit is a pressed key. A 16-entry case turns row and column into the key's value.

Pin log

Run the design to see its outputs change.

Keypad (hold a key)

Put it on a real board

  • The Sipeed Tang Nano 9K (Gowin GW1NR-9) has no a 7-segment display or a keypad: those ports go to header pins, where you can wire them.
  • The clock is set to the board's 27 MHz, and its active-low buttons and LEDs are flipped for you.
Waveform