BitFlow

Serial calculator

Put receiving and sending together. The board reads a sum like 3+4 followed by a new line, adds the two digits and sends the answer back as text with \r\n.

The answer can be one digit or two (9+9 is 18), so send the tens digit only when there is one. A small state machine works well: wait for the first digit, the plus, the second digit, the new line, then send.

lab.v
drag to turn · scroll to zoom

Loading the board…

Press Run on the board: your Verilog is turned into gates in this browser and runs here, cycle by cycle.

Goals

  • ○One-digit answers are right (3+4 → 7)
  • ○Two-digit answers are right (9+8 → 17)
  • ○Each answer ends with \r\n
Hints
  1. Store a and b as numbers (byte_in - "0") and compute sum = a + b (0–18).
  2. To send it: tens is sum >= 10, ones is sum - (tens ? 10 : 0), and each digit goes out as "0" + digit.
  3. Send one character at a time: pulse send when !busy, as in Say hello.

Pin log

Run the design to see its outputs change.

Serial terminal (type to send on rx)

 

Put it on a real board

  • The clock is set to the board's 27 MHz, and its active-low buttons and LEDs are flipped for you.

Check on my board

Flash this lesson, then connect at 115200 baud. Your browser asks which port: on a Tang Nano, try the higher-numbered one if nothing comes back.

Waveform