BitFlow

RISC-V Step 2: Register File

advanced · riscv · 220 XP

Sign in to write your solution, run it in the simulator and submit it for grading.

Sign in or create a free account →

Problem

RISC-V Step 2: Register File RV32I has 32 general-purpose registers, `x0` to `x31`, each 32 bits. An instruction like `add x3, x1, x2` reads two registers and writes one, so the register file has **two read ports and one write port**. **Interface** | Port | Dir | Width | Meaning | |------|-----|-------|---------| | `clk` | in | 1 | Clock | | `we` | in | 1 | Write enable | | `rs1`, `rs2` | in | 5 | Registers to read | | `rd` | in | 5 | Register to write | | `wd` | in | 32 | Value to write | | `rd1`, `rd2` | out | 32 | Values of `x[rs1]` and `x[rs2]` | **Behaviour** - **Reads are combinational:** `rd1`/`rd2` follow `rs1`/`rs2` immediately, with no clock. - **Writes happen on the rising edge of `clk`** when `we` is 1: `x[rd] <= wd`. A write is visible on the read ports right after that edge. - **`x0` is hardwired to zero:** writes to it are ignored and it always reads 0. Programs rely on this: `addi x1, x0, 5` means "x1 = 5". Registers other than `x0` start undefined, like real hardware; the tests write a register before reading it.

Constraints

  • Two combinational read ports, one synchronous write port.
  • x0 always reads 0, whatever was written to it.
  • No reset is needed.

Examples

Input: we=1, rd=3, wd=0xCAFE0003, rising edge

Output: x3 = 0xCAFE0003

Ordinary write

Input: we=1, rd=0, wd=0xFFFFFFFF, rising edge; then rs1=0

Output: rd1 = 0

x0 ignores writes

Input: rs1=3, rs2=3

Output: rd1 = rd2 = x3

Both ports can read the same register

Common questions

What does the RISC-V Step 2: Register File problem ask you to build?
RISC-V Step 2: Register File RV32I has 32 general-purpose registers, `x0` to `x31`, each 32 bits. An instruction like `add x3, x1, x2` reads two registers and writes one, so the register file has **two read ports and one write port**.
What constraints does RISC-V Step 2: Register File have?
Two combinational read ports, one synchronous write port.; x0 always reads 0, whatever was written to it.; No reset is needed.
What is an example input and output for RISC-V Step 2: Register File?
Input we=1, rd=3, wd=0xCAFE0003, rising edge gives output x3 = 0xCAFE0003. Ordinary write
Which Verilog concepts does RISC-V Step 2: Register File practise?
riscv, risc-v, register-file, sequential, cpu.