BitFlow

Flash an FPGA board

Plug the board in over USB, pick its bitstream and program it, right from the browser. Build the bitstream in the Sandbox (Synth → Bitstream) and it arrives here, or use one you built yourself.

This board is programmed through its flash, so the design stays after power-off.

Pick a bitstream first, or build one in the Sandbox's Bitstream tab.

Set up this computer

The same thing from a terminal

With openFPGALoader from the OSS CAD Suite:

openFPGALoader -b ice40_generic top.bin

Serial monitor

Talk to your design's UART once it runs on the board: what it sends on tx appears here, and what you type goes to rx.

8 data bits, no parity, 1 stop bit
received 0 B · sent 0 B
Connect the board's serial port to see what your design sends on tx.

On FTDI boards (iCEstick, iCEBreaker, Digilent) the serial port is the board's second interface: it keeps its normal driver even after you give interface 0 the WinUSB driver for programming. The speed must match the design (e.g. CLKS_PER_BIT = clock ÷ baud).