BitFlow

Debounce a button

A real button doesn't close cleanly: its contacts bounce for a few milliseconds, and the FPGA, fast enough to see every bounce, counts one press as several.

The starter counts presses on the LEDs, and it works for a clean press. Fix it so a press only counts once the button has stayed the same for 10 ms (CLK_HZ / 100 cycles).

lab.v
drag to turn · scroll to zoom

Loading the board…

Press Run on the board: your Verilog is turned into gates in this browser and runs here, cycle by cycle.

Goals

  • ○A clean press adds one
  • ○A bouncy press still adds one
  • ○Holding the button down adds only one
Hints
  1. Keep a stable copy of the button and a timer. While the raw button differs from stable, count; when the count reaches CLK_HZ / 100, copy it into stable.
  2. Detect the press on stable going from 0 to 1, not on the raw button.

Pin log

Run the design to see its outputs change.

Put it on a real board

  • The clock is set to the board's 27 MHz, and its active-low buttons and LEDs are flipped for you.
Waveform