BitFlow

Dim an LED (PWM)

An LED can't be half on, but it can be on half the time. Switch it fast enough and your eye sees a dimmer light: that's pulse-width modulation (PWM).

Run a 4-bit counter that goes round and round, and light LED 0 while the counter is below the switches' value. sw = 0 is off, sw = 8 is half brightness, sw = 15 is nearly full.

lab.v
drag to turn · scroll to zoom

Loading the board…

Press Run on the board: your Verilog is turned into gates in this browser and runs here, cycle by cycle.

Goals

  • ○LED 0 is on for sw / 16 of the time
  • ○The pattern repeats every 16 cycles (fast enough not to flicker)
Hints
  1. always @(posedge clk) phase <= phase + 1; with a 4-bit phase.
  2. assign led[0] = phase < sw;

Pin log

Run the design to see its outputs change.

Put it on a real board

  • The Sipeed Tang Nano 9K (Gowin GW1NR-9) has no switches: those ports go to header pins, where you can wire them.
  • The clock is set to the board's 27 MHz, and its active-low buttons and LEDs are flipped for you.
Waveform